9/22/2023 0 Comments E1399gyltOf a Document) for temporary storage on one computer for purposes of viewing, and/or That is, Licensee may access and download an electronic file of a Document (or portion Of individual Documents, or portions of such Documents, solely for Licensee's own use. (b) the right to download, store or print single copies (a) the right to browse, search, retrieve, display and view the Product Permitted and described below, each ASTM Product to which Licensee has subscribed. Revocable, nonexclusive, non-transferable license to access, by means of one or moreĪuthorized IP addresses, and according to the terms of this Agreement, to make the uses Or employee of the Licensee, at the Single or Multiple Site. To this Product if a Site License, also includes registered students, faculty or staff member, Independently administered multiple locations within one city or an organization orĬompany located in more than one city, state or country, with central administration for all locations. Sites within one city that are part of a single organization unit administered centrally įor example, different campuses of the same university within the same city administered centrally. The copyright notice or other notice contained in the ASTM Product or Documents.Ī single unique computer, with an individual IP address (in both electronic file and hard copy) belong to ASTM. This is not a sale all right, title and interest in the ASTM Product or Documents (Licensee) have no ownership or other rights in the ASTM Product or in the Documents. ("ASTM"), 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959 USA, except as may beĮxplicitly noted in the text of the individual Documents. Promptly exit this page without entering the ASTM Product.Ĭompilation and as individual standards, articles and/or documents ("Documents") by ASTM If you do not agree to the terms of this License Agreement, IMPORTANT- READ THESE TERMS CAREFULLY BEFORE ENTERING THIS ASTM PRODUCT.īy purchasing a subscription and clicking through this agreement, you are entering intoĪ contract, and acknowledge that you have read this License Agreement, that you understand It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. This test method is intended for the following uses:ġ.1.1 To verify movement capability information supplied to the user by the producer,ġ.1.2 To standardize comparison of movement capability by relating it to specified nominal joint widths.ġ.1.3 To determine the cyclic movement capability between specified minimum and maximum joint widths without visual deleterious effects, andġ.1.4 To provide the user with graphic information, drawings or pictures in the test report, depicting them at minimum, maximum, and nominal joint widths during cycling.ġ.2 This test method is intended to be used only as part of a specification or acceptance criterion due to the limited movements tested.ġ.3 The acceptable standard units of measure are SI units and the equivalent inch-pound units are expressed in parenthesis.ġ.4 This standard does not purport to address the safety problems associated with its use. 1.1 This test method covers testing procedures for architectural joint systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |